4.34 DESIGN REQUIREMENTS FOR BAKING PANS
4.34.1 Definitions
4.34.1.1 Baking Pan: A container, of single or multiple compartments,
designed and constructed for use in the baking of bakery foods.
To
comment or make suggestions regarding this standard or
begin a new discussion on this standard click here
4.34.1.2 Product Zone: The product zone of baking pans shall
include all inside surfaces and those portions of the outside
of the pan that may come in contact with the inside surfaces
of an identical pan.
To
comment or make suggestions regarding this standard or
begin a new discussion on this standard click here
4.34.1.3 Reinforcing Member: A separate component added to
the basic pan for the purpose of strengthening the individual
pan unit.
To
comment or make suggestions regarding this standard or
begin a new discussion on this standard click here
4.34.1.4 Pan Assembly: Separate individual pan units joined
through the attachment of one pan unit to another, or through
the use of additional components.
To
comment or make suggestions regarding this standard or
begin a new discussion on this standard click here
4.34.2 Specific Design Requirements
4.34.2.1 All baking surfaces shall be of a corrosion-resistant
material, that is cleanable and coatable with release coatings.
To
comment or make suggestions regarding this standard or
begin a new discussion on this standard click here
4.34.2.2 All individual components of baking pans shall not
have sharp edges.
To
comment or make suggestions regarding this standard or
begin a new discussion on this standard click here
4.34.2.3 Top rim edges shall be smooth and the bead shall
be curled, cleanable and self draining.
To
comment or make suggestions regarding this standard or
begin a new discussion on this standard click here
4.34.2.4 The corners of the reinforcing members attached to
non-product zone of pans or assemblies shall be required to
have a radius.
To
comment or make suggestions regarding this standard or
begin a new discussion on this standard click here
4.34.2.5 Top rim edges constructed with a reinforcing member
in the rim should be sealed or provided with a minimum of 1/8
inch (3mm) space between the pans and the reinforcing member.
To
comment or make suggestions regarding this standard or
begin a new discussion on this standard click here
4.34.2.6 The exterior pan assembly shall not have protruding
wires or metal appendages.
To
comment or make suggestions regarding this standard or
begin a new discussion on this standard click here
4.34.2.7 All welding shall be free of burrs, slag or sharp
edges.
To
comment or make suggestions regarding this standard or
begin a new discussion on this standard click here
4.34.2.8 Exposed welds from wire welding must be of corrosion
resistant materials.
To
comment or make suggestions regarding this standard or
begin a new discussion on this standard click here
4.34.2.9 Reinforcing members should be wrapped with a maximum
opening of 1/16 inch (1.5mm) and maximum space (gap) of 1/64
inch (0.4mm) between two materials.
To
comment or make suggestions regarding this standard or
begin a new discussion on this standard click here
4.34.2.10 Areas of baking pans that tend to trap contaminants
shall allow for efficient cleaning and drainage.
To
comment or make suggestions regarding this standard or
begin a new discussion on this standard click here
4.34.2.11 When notching is required to form corners and the
sheet metal is wrapped over non-corrosive resistant materials,
the non-corrosive resistant materials shall be totally concealed.
To
comment or make suggestions regarding this standard or
begin a new discussion on this standard click here
4.34.2.12 All exposed fasteners shall be of corrosion resistant
materials.
To
comment or make suggestions regarding this standard or
begin a new discussion on this standard click here